The display
order defines the sequence in
which the units within this specimen
will appear on e.g. a label. The first unit will be
printed in the header of the label, others
are included in the text below. You
can change the display order by using
the 
buttons.
If a unit should not appear
on the label, transfer it to the hide list
using the 
button. The 
button returns it to the list to be
shown on a label. The first unit can
not be transferred to the hide list.
The upper section shows the display orders of
the units within the whole specimen. The lower section shows the
display orders in a specimen
part. If you print a label without reference to a part, the
display order for the
entire specimen as in the upper section will be used. This part
is also accessible if
you click on the
button in the right panel of the upper tree, which will appear
if you e.g. select
the specimen.
If you print a label with
reference to a part, the
display order for the part as in the lower section will be used.
This area will be
shown when you select a specimen part in the lower tree. In
addition to the display
order you can specify
whether an organism is present in a selected part of a
specimen. With the button you can transfer all organisms into the part.
To change the sequence of the parts according to e.g. the name instead of setting all entries one by one, you may choose among the options shown in the image below (Name, Identifier, ID).
